How to setup DWL-G700AP by running Wizard
To configure DWL-G700AP follow the steps below.1. Assign static IP address on your computer
If there is no other DHCP server connected to your computer you need to assign a static IP address on your computer. It should be in the range of 192.168.0.X
Where X should be between 1 to 254 except 50.
To know how to assign static IP address on your computer click on the link below.
Assign static IP address from command prompt
2. Connect your computer to Access Point
You should connect the Wireless Access Point (DWL-G700AP) to your computer using an Ethernet cable and power on the Access Point.
3. Access the Configuration page from your computer
To access the configuration page of D-link Access Point DWL-G700AP ,open your Internet Explorer or other browser and type 192.168.0.50 on the address bar. Press enter.
Now it will prompt you to enter admin user name and password to log on. Enter the following details.
Default admin username: admin
Default admin password :
There is no default admin password.
4. Click on Run Wizard
Now it will show the next steps in configuration. Click next.
Now the wizard will prompt you to set a new password for the Access Point. You need to confirm the Access Point password.
After set the password click next.
After Selecting the SSID and wireless channel, click Next.
Now you need to select the Wireless encryption which matches the Wireless router. After selecting the encryption you need to enter the wireless key. Now click Next to continue.
Now you need to click on the Restart button. After restarting the Wireless Access Point you can use it on your network.
Other Wireless Articles
Home
9 comments:
i try and try but can never get the interface after typing 192.168.0.50
Tried reseting the AP several times and different methods but i just cant get to the goddamn ap interface :(
i've got to the config wizard online, but the changes never takes effect.
Please try the following steps once again and try:
1. Reset AP by pressing the reset hole using pen for 30 sec
2. Assign IP address 192.168.0.1 to your computer
3. Connect AP to the computer using Ethernet cable and follow the steps in the above post.
Excellent tutorial! Thanks
thank you so much
that was so useful
plz help me me, i want to reset my AP but its not accepting default password and username. i have tried the given mehthod.????
Please follow the link below to know how to reset your Access Point.
How to Reset Access Point
Help! I click on restart but it doesn't load the page, as it's not connected to the internet
I recommend you to perform a power cycle after configuring D-link Access Point.
How to Power Cycle Wireless Access Point
If the issue persist follow the steps provided in the link below.
http://www.corenetworkz.com/2011/04/cannot-access-internet-after-installing.html
Well thanks for your article. I would like to know the manual steps to setup D-link Access Point? Is there any difference between different D-link Access Point models ?
Post a Comment